Toshiba aircon 41 error code
Use this Toshiba 41 error code guide to decide when to stop resetting, what to capture, and what to check before parts are quoted.
What does Toshiba 41 mean?
Toshiba 41 is listed as uART communication error between RAC interface and RAC in Wall-Mounted Split, Single-Split, Inverter Split rows such as RAC TU2C-LINK Interface - Residential AC type. The loaded row is source-backed by official diagnostic material. Confirm the exact model, series, or signal row before accepting a parts quote.
Loose, corroded, crossed, or damaged indoor-outdoor signal wiring.
Terminal block, connector, or junction fault on the indoor or outdoor side.
Indoor or outdoor PCB communication circuit fault after wiring is proven sound.
What to do now
Use these steps before another reset, signal-wire check, or PCB quote.
Treat it as a fault signal
If 41 returns or cooling is still abnormal, stop treating it as a simple reset issue.
Reset 41 once
Capture the 41 display first, then power-cycle once only and note whether the same fault returns.
Send these to us
41 error code, a clear display photo, Toshiba model stickers, affected rooms, reset result, and whether one room or every room failed
What to check before repair
Use this split to separate safe evidence capture from the tests a technician should prove before quoting parts.
| You can check | Technician should confirm |
|---|---|
| Before resetting 41, take a clear display photo. | Match 41 against the exact model-family source row before quoting parts. |
| Capture the Toshiba indoor and outdoor model stickers so the correct family row is used. | Test communication terminals, cable continuity, polarity, and outdoor power. |
| Note whether one room, several rooms, or the whole system is affected, plus whether it returns after one reset. | Read indoor and outdoor PCB indicators only after the signal path is proven sound. |
What changes the next step
These clues decide whether the first check is room-side, shared outdoor-side, refrigerant-side, source-table, or model-family confirmation.
| What you see | What it points to |
|---|---|
| Only one indoor unit shows 41. | The affected room, indoor board path, wiring route, or local component should be checked first. |
| Several rooms or the outdoor unit show the same 41 fault. | The shared outdoor side, power path, communication trunk, or refrigerant circuit needs priority checking. |
| The fault returns immediately after one reset. | Start with the source-row diagnostic branch before approving parts. |
| The model family is different from the row you found online. | Use the model or series filter first; same-looking codes can still belong to different diagnostic tables. |
| The model belongs to Wall-Mounted Split, Single-Split, Inverter Split rows such as RAC TU2C-LINK Interface - Residential AC type. | The loaded row is source-backed by official diagnostic material. Use the matching source row before quoting parts. |
Wiring or PCB decision
Toshiba 41 should start with terminal, signal-cable, and power checks. PCB replacement only makes sense after the communication path is proven sound.
A loose terminal or bad junction is a targeted repair once the path is confirmed.
Signal-wire replacement depends mostly on access through trunking, ceiling, or concealed routes.
PCB cost should be weighed against age only after wiring and power checks pass.
Read next
Use these if the quote mentions the parts, checks, or repair path this code points to.
Other Toshiba error codes
If the code you're seeing isn't 41, jump to one of these or browse the full Toshiba list.
Ready to get started?
Tell us what’s going on. Symptoms, setup, photos, anything we should know. We’ll assess and come back with the right next step.