On this page
What is the price of a gas top-up, by refrigerant?
A top-up is priced per unit by refrigerant type, and R32 has the widest market range. The table sets Snowflake's rate beside the published rates of five to seven Singapore operators.
The model sticker on the indoor or outdoor unit names the refrigerant. Read it before comparing quotes.
| Refrigerant | Market range in Singapore | Our rate |
|---|---|---|
| R32 | $80–$250 per unit | $120–$200 |
| R410A | $80–$165 per unit | $80–$150 |
| R22 | $50–$155 per unit | $60–$100 |
Operators price per unit or per outdoor circuit, and some quote a starting price. A larger unit, or a charge well below its rated weight, sits at the top of the range.
Market ranges: published rates from 7 Singapore operators; published rates from 6 Singapore operators; published rates from 5 Singapore operators. Checked 18 Nov 2026.
When a top-up is the wrong job
Refrigerant is not consumed in normal running. A unit that needs more has either been undercharged or is leaking, as Mitsubishi Electric's FAQ puts it.
If cooling faded again after an earlier top-up, the leak is still open. Pay for a leak test instead of a second refill.
- First top-up on an older unit, cooling faded slowly: ask for pressure readings before agreeing.
- Second top-up within a year: book a leak test, not more gas.
- Ice on the pipe or a hiss at a joint: leave the unit off and book a leak test.
What a fair top-up quote shows
A quote should name the refrigerant and the readings that showed the charge was low. Weak cooling alone is not a reading; a dirty coil or a slow fan feels the same.
The invoice should state the amount of gas added. A small amount points to a slow seep; most of a full charge points to a large opening.
R22 units and older systems
R22 is the refrigerant in older units. Each system takes only the gas named on its sticker, so an R22 unit cannot be topped up with R32.
An R22 unit that keeps losing gas is a candidate for replacement. The end-of-life signs are listed in a separate guide.