On this page
Which aircon repairs cost the most?
A coil or a compressor is the dearest repair on a home aircon, reaching well above the rest. A blocked drain, a leak test or a capacitor sits at the cheap end.
The ranking below uses published Singapore operator rates, with Snowflake Aircon Services' own rates beside them.
Scroll to see more columns
| Repair | Market range in Singapore | Our rate | What moves the price |
|---|---|---|---|
| 1. Blocked drain line cleared | $50–$150 per unit | Quoted per job | Whether the blockage is at the unit or deep in a concealed pipe |
| 2. Gas leak test, single-split system | $50–$180 per job | Quoted per job | The system size and how the test is run |
| 3. Capacitor replaced | $70–$150 per job | Quoted per job | Compressor or fan capacitor, and the model |
| 4. Blower wheel replaced, wall-mounted unit | $80–$150 | Whether the wheel is still supplied for the model | |
| 5. Gas top-up after the leak is sealed, R32 | $120–$200 | How much gas the system needs | |
| 6. Fan motor replaced, wall-mounted indoor unit | $120–$400 per job | $220–$320 | Motor model, stock and access |
| 7. Circuit board (PCB) replaced, indoor board | $150–$400 per job | $180–$320 | Indoor, outdoor or inverter board, and supply |
| 8. Indoor or outdoor coil replaced | $200–$1,800 per job | Quoted per job | Unit size and whether the coil must be ordered |
| 9. Compressor or condensing unit replaced | $300–$1,500 per job | Quoted per job | System size, gas and whether the whole condenser is swapped |
| Diagnostic visit to name the fault first | $30 / visit | Waived if you go ahead with the quoted repair |
Ranked by the low end of each range, or of Snowflake's own rate where no market range is published. A job's place in a range depends on the brand, the model and access.
Market ranges: published rates from 4 Singapore operators; published rates from 3 Singapore operators; published rates from 6 Singapore operators. Checked between 18 Nov 2026 and 20 Nov 2026.
Where the ranges come from
Each range is the lowest to the highest figure from at least three Singapore operators' published rates for the same job, checked on 18 or 20 November 2026. Rows are ordered by the low end.
Why the same repair has a wide range
Part supply sets most of the spread. A part stocked for the model is a short job; one that must be ordered, or exists only as a used part, costs more and takes longer.
Access adds the rest. A unit on a high ledge, behind a false ceiling or on a concealed pipe run takes longer to reach than an open wall unit.
The cheap faults that look expensive
A diagnostic visit names which one applies before anything is replaced.
- No cooling with the outdoor unit humming: on a non-inverter unit this can be a capacitor, not the compressor.
- Water dripping indoors: usually the drain line, not a gas leak.
- Unit dead with no lights: sometimes the supply or a fuse, before the board.
- Noise from the indoor unit: often the blower wheel, not the motor.
Where repair stops making sense
The coil and compressor rows are where a replacement quote is worth having. On an aircon over ten years old, a new coil or compressor goes into a system whose other parts are equally worn.
Boards are replaced, not repaired. Snowflake fits a new or matching board and quotes it once the model is confirmed.