On this page
How much does an aircon replacement cost?
Published Singapore rates for supply and install rise with the number of indoor units, from System 1 to System 4. The brand and the unit sizes move a job across each range.
Snowflake Aircon Services' Starmex packages are listed with the market ranges. They include new piping up to 50 feet per indoor unit and disposal of the old system.
| System | Market range in Singapore | Our rate |
|---|---|---|
| System 1, one indoor unit | $700–$3,100 per job | |
| System 2, two indoor units | $1,400–$5,200 per job | $2,600 |
| System 3, three indoor units | $1,800–$7,000 per job | $3,750 |
| System 4, four indoor units | $2,400–$9,000 per job | $4,700 |
| Same system with the existing piping reused | Only one operator publishes a reuse price by system; the price falls by the piping and trunking left in place, once the old run passes its checks. |
Market ranges are supply and install, and most do not say whether the piping is new or reused. The brand, the tick rating and the indoor unit sizes move a job across the range.
Market ranges: published rates from 4 Singapore operators. Checked 20 Nov 2026.
What reusing the piping saves, and what it risks
Reuse saves the copper, the insulation, the trunking and the labour to run them. No three operators publish that saving the same way, so it is not shown as a range.
The risk is a leak or a blockage that the new system inherits. Finding it later means opening the trunking or the ceiling again.
When the old piping can be reused
Reuse is a test, not an assumption. Every item below has to pass before the new units go on the old run.
Makers set their own conditions, so check the new unit's installation manual before agreeing to reuse.
- The pipe diameter and wall thickness match the new unit's specification.
- The flares suit the new refrigerant, for example R32.
- The old oil is clean; dark oil or a past compressor failure means cleaning or new pipe.
- The run passes an airtight pressure test and is vacuum dried.
- The insulation is intact, with no cracks, wet patches or rust underneath.
- The route and length stay inside the new unit's limits.
When new piping is the better buy
Lay new piping when the old run fails any check, or when the room layout changes. Do the same when the old system had a leak that was never found.
Snowflake recommends Mitsubishi Electric Starmex in its own installations. The reasons are reliability, ease of servicing and how readily its parts are found.
Getting a quote you can compare
Ask each installer to state in writing whether the quote reuses the piping. Two quotes for the same system are only comparable when both name the piping basis, the brand and the indoor unit sizes.