Skip to main content

New Condo Key Collection Aircon Defect Inspection Guide

Developer-installed condominium aircons must be stress-tested immediately after TOP key collection, while the 12-month defects liability period (DLP) remains active. Running every fan coil and concealed ducted unit together for at least 90 minutes exposes hidden drain leaks, weak airflow, and remote pairing mix-ups before move-in carpentry closes access.

On this page

Why brief five-minute cooling tests miss real handover faults

Switching each bedroom aircon on for five minutes during a brisk joint walk only proves the unit powers up. Concealed ducted living-room units and wall-mounted coils need sustained condensation build-up to reveal flat drainage slopes, missing access panels, or uninsulated duct collars sweating onto fresh ceiling boards.

Logging defects formally through the developer's rectification portal before renovation begins is essential. Once a private contractor alters false ceilings or relocates grilles, developers routinely decline DLP responsibility for adjacent piping or airflow complaints.

Why brief five-minute cooling tests miss real handover faults summary table
Inspection zonePractical key-collection testDefect to record for developer
Living room ducted unitRun at 18C high fan for 90 minutesCheck ceiling hatch for sweating, drip marks, or loud rattling
All bedroom wall unitsRun simultaneously and verify supply temperatureNote crossed remote wiring, vibration, or lukewarm rooms
Condensate drainage pathPour clean water gently into reachable drain panReport slow backing-up or water pooling near floor trap
Outdoor condenser ledgeInspect louvre clearance and isolator labellingFlag trapped hot-air recirculation or loose weatherproof covers

Checking concealed ducted hatches and maintenance clearance

Many new Singapore condos pair wall-mounted bedroom units with a ceiling-concealed ducted fan coil above the living hall or master walk-in area. Open the service hatch carefully to confirm technicians can physically slide out the washable filter, reach the condensate pump if fitted, and inspect the insulated flexible duct collars without tearing plasterboard.

Also look inside the outdoor aircon ledge for proper vibration pads and neat weatherproof conduit seals. Missing anti-vibration rubber mounts transmit low-frequency compressor hum straight through reinforced concrete walls into adjoining master bedrooms at night.

Separating developer defects from brand warranty claims

Keep every brand warranty card, serial-number sticker, and handover commissioning sheet supplied in the developer's welcome pack. Factory defects on compressors or PCBs fall under the equipment manufacturer's warranty (typically counted from TOP or delivery date depending on project terms), whereas mis-sloped drains, squashed ducts, and crossed control cables belong strictly to the developer's main contractor.

If an error code flashes or a breaker trips during testing, do not attempt to reset tripped circuit breakers or force-restart the isolator. Photograph the blinking code and submit it immediately on the defects sheet so the developer's M&E subcontractor investigates safely.

Common questions

How long should new condo aircons run during a TOP defect check?
Running all indoor units together at 18 to 20 degrees Celsius for 60 to 90 minutes generates enough steady condensate to test drain gravity flow and concealed insulation seams. Short five-minute switch-ons rarely produce enough water to expose slow ceiling drips.
Should owners service developer-installed aircons during the 12-month defects period?
Light filter rinsing keeps dust from post-handover renovations out of fresh coils, yet full dismantling should wait until all logged developer aircon defects are rectified and signed off. Premature third-party modifications can complicate builder accountability during the defects liability period.
What happens if an indoor unit controls the wrong room on key collection?
Crossed control wiring happens occasionally on multi-split projects when signal cables are swapped at the outdoor terminal block. Document the exact room mismatch on the developer defect form so the original electrical team re-terminates wires under DLP without voiding warranties.

Sources