Skip to main content

Gecko and Lizard Short Circuits on Aircon Circuit Boards

Asian house geckos crawl along unsealed trunking gaps into warm aircon enclosures and bridge live terminals across indoor or outdoor PCBs. That conductive path burns traces instantly, triggers electrical trips, and leaves a sharp acrid smell requiring full board replacement.

On this page

How house lizards enter aircon electrical housings

Tropical humidity drives common house lizards (cicak) toward warm electronics after dusk, especially behind outdoor condenser panels on HDB ledges and inside trunking chases entering bedrooms. Unsealed wall penetrations around copper piping, loose condenser grommets, and cracked plastic knockout tabs give small reptiles easy entry straight onto energized relays and inverter modules.

Once a reptile touches high-voltage terminals and an adjacent grounded heat sink, fault current flashes across the circuit board. Homeowners typically hear a faint pop, smell singed plastic or ozone, and see a dead indoor display or a tripped circuit breaker. Do not toggle a tripped breaker back on or open electrical casings, as carbonized debris can re-ignite another arc.

How house lizards enter aircon electrical housings summary table
Observed symptomLikely affected assemblyRecommended action
Instant breaker trip plus burnt smell outsideOutdoor inverter PCB or compressor terminal blockLeave isolator off and schedule an electrical board check
Indoor unit dead with intact wall socket powerIndoor control PCB fuse or blown power sectionInspect board damage and quote OEM board replacement
Blinking timer lamp with communication faultDamaged signal circuit between outdoor and indoor boardsTest inter-unit wiring before fitting a new board
Droppings near wall trunking without active faultUnsealed masonry hole behind indoor fan coilPack hole with silicone or putty during servicing

Why damaged circuit boards are replaced rather than repaired

Scorched aircon PCBs suffer hidden trace delamination, heat-stressed optocouplers, and micro-fractures inside multi-layer fiberglass boards that bench soldering cannot reliably restore. Even if a blown surface fuse is bridged, surviving power transistors often fail days later and risk damaging the outdoor compressor or fan motor.

Snowflake Aircon Services always replaces faulted circuit boards with genuine manufacturer assemblies rather than attempting component-level soldering. Standard manufacturer warranties in Singapore exclude pest ingress, so confirming board availability and matching exact outdoor and indoor model numbers prevents mismatched control firmware.

Sealing trunking gaps to block repeat reptile entry

Fitting a fresh circuit board without sealing access routes invites another outage within months. Technicians should pack wall core-drill openings around insulated copper pipes with non-hardening aircon putty, secure loose PVC trunking end caps, and verify rubber cable glands on outdoor condenser covers sit flush.

Keeping outdoor ledges clear of clutter and trimming overhanging planter foliage beside condo compressors also lowers insect prey that attracts geckos toward your unit.

Common questions

Does Singapore manufacturer aircon warranty cover gecko damage to a PCB?
Manufacturer aircon warranties across Singapore generally exclude damage caused by lizards, ants, cockroaches, and other pests entering electrical compartments. Homeowners normally pay for diagnostic inspection and a genuine replacement board out of pocket, while technicians inspect and seal trunking entry gaps to lower recurrence risk.
Can a technician clean and solder a gecko-burnt aircon circuit board?
Burnt aircon PCBs should be replaced completely rather than soldered at component level. Electrical arcing leaves conductive carbon tracks across multi-layer copper traces and weakens neighboring inverter parts, creating ongoing tripping hazards or secondary compressor damage if the scorched board stays energized.
What should a homeowner do right after smelling burnt plastic from an aircon?
Switch off the remote control, keep tripped circuit breakers in the off position, and avoid opening plastic covers around energized wiring. Ventilate the bedroom naturally and photograph the model label on the indoor or outdoor casing so a technician can check replacement board stock quickly.

Sources