On this page
Verified meanings of Gree E1, E2, E4 and E5 codes
Gree multi-split condensers installed across HDB and private apartments, including 5-tick models such as GWCD-MS21/O and GWCD-MS28/O, rely on four core protection cutoffs to prevent compressor burnout. Although E1, E2, E4 and E5 all stop bedroom cooling, each signals a distinct physical stress inside the aircon.
Turn the bedroom wall unit off using the remote controller as soon as any code flashes. Keep wall isolators and distribution breakers untouched rather than forcing resets, especially after an E5 over-current shutdown.
| Gree Code | Verified Protection Fault | Key Field Checks |
|---|---|---|
| E1 | High-pressure protection | Inspect fouled outdoor condenser coil, blocked ledge exhaust, slow outdoor fan, or excess gas. |
| E2 | Evaporator anti-freezing protection | Check clogged indoor blower wheel, dirty filters, low refrigerant charge, or indoor coil sensor. |
| E4 | High discharge temperature protection of compressor | Verify refrigerant leak points, clogged capillary/expansion valve, and discharge probe reading. |
| E5 | Over-current protection | Measure flat supply voltage, compressor amp draw, outdoor heat rejection, and outdoor PCB. |
Why airflow blockage drives E1 high pressure and E2 icing
Poor heat transfer sits behind a large share of Singapore E1 and E2 calls. When thick lint coats the outdoor condenser fins or balcony screens trap hot exhaust air around the compressor, condensing pressure spikes until E1 cuts operation.
Inside the bedroom, E2 anti-freezing protection trips when restricted indoor airflow over a jelly-clogged blower barrel or neglected filters lets evaporator coil temperature plunge toward zero degrees. Low refrigerant pressure produces identical icing, so technicians verify both indoor airflow and suction pressures.
Tracing E4 compressor heat and E5 over-current trips
Code E4 signals excessive compressor discharge temperature, commonly traced to slow R32 refrigerant leakage at flare joints, partial valve restriction, or a drifted discharge thermistor. Technicians pressure-test and fix leaks before recharging refrigerant by weight.
Code E5 monitors excessive electrical current draw caused by high head pressure, unstable incoming voltage, a stalling compressor, or a failing current-sensing outdoor board. Where probing confirms a damaged outdoor inverter PCB, full board replacement is carried out rather than component-level soldering.
Common questions
Can washing dirty indoor filters and coils resolve a Gree E2 error?
How do Gree E1 high pressure and E4 high discharge temperature differ?
What checks are needed after a Gree E5 over-current protection shutdown?
Sources
Sources checked .