Skip to main content

Mitsubishi Heavy Aircon Leaking Water: Causes and Fixes

A Mitsubishi Heavy Industries aircon leaking water in a Singapore flat usually stems from algae jelly blocking its condensate drain line, though iced coils or torn pipe insulation can drip too. Switch the unit off via remote and check safe surface signs first.

On this page

Where water leaks appear on Mitsubishi Heavy indoor units

Pinpointing exactly where drops emerge separates a simple drain choke from an insulation or icing fault. Watch the front casing, rear wall seam and side trunking briefly before turning the aircon off.

Continuous dripping from the front bottom lip almost always points to an overflowing front condensate tray.

Where water leaks appear on Mitsubishi Heavy indoor units summary table
Drip locationMost likely cause on MHI unitsService fix required
Front bottom grille or louvreAlgae slime blocking the primary drain tray outlet or PVC pipeVacuum clear drain line, wash drain pan and flush evaporator coil
Running down wall behind the unitChoked rear auxiliary drainage channel or tilted mounting plateDismantle casing, clear rear drain channel and re-level bracket
Sudden gush after weak cold airDust-choked filter or low refrigerant freezing the coil, then thawingWash mesh filters; if icing recurs, pressure-test refrigerant loop
Sweating along PVC trunking runSplit, compressed or saturated foam pipe insulationRe-wrap exposed copper joints with fresh closed-cell insulation

Safe homeowner checks before booking a technician

Turn the unit off using the remote control and place a towel beneath the casing to protect parquet or laminate flooring. Lift the front panel gently to inspect the plastic mesh filters and wash any heavy dust coat under tap water, letting them air-dry completely before refitting.

Never pry open the electrical box, pour corrosive drain chemicals into the indoor pan, or force a tripped circuit breaker back on.

Maintenance schedule and Singapore warranty boundary

Under KM Marketing's Mitsubishi Heavy Industries Singapore warranty terms, water leaks from algae buildup, clogged filters or installation piping slope fall outside factory hardware coverage. Quarterly vacuuming of the condensate pan keeps SRK wall units drip-free in humid bedrooms.

If water still returns within days of cleaning the filters, the blockage sits deeper in the PVC drain run or rear tray and needs technician wet-vacuuming.

Common questions

Why does my Mitsubishi Heavy aircon drip water only after running for two hours?
Delayed dripping after one to two hours typically happens when biofilm partially narrows the PVC drain pipe or drain tray neck. Condensate fills the pan slowly faster than water can trickle past the clog, overflowing once the tray reaches its rim.
Does a water leak on a Mitsubishi Heavy aircon mean it needs a gas top-up?
Most Mitsubishi Heavy water leaks are caused by choked drainage rather than missing refrigerant. Low gas causes leaks only when ice visibly builds on the evaporator coil and melts into water; a technician should inspect the drain line and coil temperature before adding refrigerant.
Will KM Marketing cover a leaking Mitsubishi Heavy aircon under warranty?
KM Marketing's Singapore warranty covers factory manufacturing defects in equipment components, not water leaks caused by dirty filters, algae-blocked drain pipes or installation pipe gradients. Routine preventive servicing by a qualified local technician clears drainage leaks cleanly without voiding equipment coverage.
Is it safe to keep running a dripping Mitsubishi Heavy unit overnight?
Continuing to run a dripping indoor unit risks water seeping into the internal fan motor or control PCB, warping nearby carpentry and staining paintwork. Switch the unit off at the remote until the clogged drain path or insulation defect is cleared.

Sources