On this page
Repair or replace an R22 aircon with a leak?
Replace it when the leak is in a coil or keeps returning. Repair it only when the leak is at an accessible joint and the rest of the unit is sound, because R22 supply is being cut each year.
Singapore must phase out HCFCs such as R22 by 1 January 2030, with import quotas cut every year from 2026. Existing R22 units may still be serviced, but the gas will get scarcer.
| Option | Market range in Singapore | Our rate |
|---|---|---|
| Leak test to find the leak | $50–$180 per job | Quoted per job |
| R22 gas after the leak is sealed | $60–$100 | |
| Coil replaced, if the leak is in the coil | $200–$1,800 per job | |
| Replace with a new System 2, any brand | $1,400–$5,200 per job | $2,600 |
A leak at a joint is the cheapest repair; a coil leak on an R22 unit is usually the point to replace. New systems run on R32, so old R22 piping is reused only after checks.
Market ranges: published rates from 4 Singapore operators. Checked between 18 Nov 2026 and 20 Nov 2026.
When an R22 repair still makes sense
Have the leak located and sealed before any gas goes in. Topping up R22 into a leaking circuit spends a shrinking resource on gas that escapes again.
- The leak is at a flare joint or valve that can be remade on the visit.
- The compressor and coils are sound, and cooling was good before the leak.
- You plan to replace the system within a year or two anyway, and need it to last until then.
Why replacement usually wins
Most R22 systems still in use are old, so the coils, compressor and board have all aged together. A coil repair puts money into one old part of an old system.
A new system runs on current refrigerant, which keeps future gas repairs simple to source.
What happens to the old piping
Old R22 piping can sometimes be reused for an R32 system, but only after it is checked, cleaned where needed and pressure tested. Many replacements lay new piping instead.
The old R22 should be recovered from the system before it is removed, not released.