On this page
How to switch your aircon remote back to metric degrees
Every residential split system sold in Singapore runs on Celsius by default, yet OEM and universal remotes support Fahrenheit for global markets. Sitting on the handset or pressing two buttons while wiping it flips the scale overnight.
Switching back is done purely on the remote controller, then sent to the indoor wall display the next time you tap Temp Up or Temp Down.
| Brand or remote type | Key combination to toggle °F / °C | Notes for Singapore models |
|---|---|---|
| Midea, Gree, PRISM+ OEM remotes | Hold Temp Up (+) and Temp Down (-) together for 3 seconds | Same pair toggles scale on some remotes; check if Mode + Temp (-) is printed |
| Gree / universal remotes (Chunghop, K-1028E) | Power remote off, then hold Mode + Temp Down (-) for 3 seconds | Some universal handsets carry a dedicated °C/°F button or pinhole |
| LG remotes | Hold Room Temp or Swing / °C-°F button for 5 seconds | LG ThinQ app also carries a temperature-unit toggle under app settings |
| Samsung remotes | Hold Set / Temp or switch temperature unit inside SmartThings app | Wall-unit LED updates on the next infrared command |
| Daikin / Mitsubishi / Panasonic | Singapore ARC/SG remotes are °C-only; check wall controller menu or mobile app | If an indoor LED shows two letters or numbers like F3 or 68, check error codes first |
Quick conversion while the display is stuck on 68 to 77
Knowing the rough Fahrenheit equivalents prevents freezing the bedroom or over-running the compressor while you find the toggle sequence. Seventy-seven degrees Fahrenheit equals 25°C, the National Environment Agency's recommended Singapore setting.
Setting 61°F equals 16°C, which forces an inverter compressor to run near maximum load all night and can trigger heavy pipe condensation in humid HDB bedrooms.
- 68°F = 20°C (very cold; high electricity draw in Singapore flats).
- 72°F = 22°C (cool bedroom setting).
- 75°F = 24°C (balanced comfort for most Singapore rooms).
- 77°F = 25°C (NEA recommended baseline for energy efficiency).
Make sure the wall LED is not showing an error code
Homeowners occasionally mistake a two-character fault code on the indoor unit LED panel for a Fahrenheit number. Numbers between 60 and 86 that rise and fall when you tap the temperature arrows are Fahrenheit degrees.
A flashing code such as F3, E5, CH35 or 88 that ignores the temperature buttons is a fault indicator, not a scale switch. Look up the exact brand code on the error-code directory before changing any settings.
When the indoor display stays stuck after switching
Point the remote straight at the indoor receiver and tap Temp Up once after toggling to °C so the new signal reaches the wall unit. On smart WiFi-linked units, check the brand mobile app as well, because an app set to Fahrenheit can flip the wall display back on the next schedule.
If the indoor wall panel stays scrambled or shows partial missing segments regardless of remote commands, the indoor display PCB has moisture or LED damage rather than a scale issue. Snowflake Aircon Services inspects display boards during routine service visits and confirms whether replacement is needed.
Common questions
Why is my aircon suddenly showing 72 or 77 instead of 25?
How do I switch a Midea or Gree remote back to Celsius?
Can a smartphone app change my aircon display to Fahrenheit?
How do I tell a Fahrenheit reading apart from an aircon error code?
Sources
Sources checked .