Skip to main content

System 4 vs System 5 Aircon: When One Unit Bottlenecks

A System 5 connects five indoor units to one outdoor condenser, which works only when rooms run in shifts rather than all at once. Turning all five units on simultaneously forces heavy capacity sharing, making two separate condensers stronger whenever ledge space allows.

On this page

System 4 vs System 5: how shared compressor capacity behaves

Multi-split aircons rely on diversity, meaning manufacturers expect you to run some rooms by day and bedrooms at night rather than every indoor unit together. On NEA's register (checked 21 November 2026), flagship 5-tick System 4 condensers deliver 6.93 to 8.62 kW (Mitsubishi Electric MXY-4H33VG / 4H38VG, Daikin MKM85VVMG / MKM100ZVMG), while System 5 outdoor units such as Mitsubishi Electric MXY-5H48VG (9.10 kW) and Toshiba RAS-5M51U2ACVG-SG (8.31 kW) stretch slightly higher.

Yet five indoor fan coils (for example 18k + 9k + 9k + 9k + 9k BTU) total 54,000 BTU, or roughly 15.8 kW of connected indoor load against an 8.3 to 9.1 kW condenser. Turn all five on during a hot Sunday gathering and every room receives noticeably less than its nameplate rating.

System 4 vs System 5: how shared compressor capacity behaves summary table
Comparison pointSystem 4 (4 indoor units)System 5 (5 indoor units)
Typical NEA outdoor capacity6.9 to 8.6 kW (5-tick multi-split)8.3 to 9.1 kW (5-tick multi-split)
Day/night split usage (2–3 rooms at once)Strong, brisk cooling across active roomsWorks well if living/study run by day and bedrooms at night
All rooms switched on togetherMild slowdown in peak afternoon heatClear capacity bottleneck; bedrooms or living room feel slow to chill
Failure exposureOne outdoor fault stops 4 roomsOne outdoor fault or gas leak stops all 5 rooms at once

Why System 5 makes sense only when a second ledge is impossible

If you own a 5-room HDB flat with an added study room, or a 4-bedroom condo restricted by MCST rules to a single aircon ledge, System 5 solves the physical constraint of cooling five rooms from one outdoor footprint.

Whenever the property has two ledges or space for a System 3 + System 2 split, two separate condensers deliver far better peak cooling, lower per-unit diversity stress and built-in backup if one condenser fails.

Electrical loading and piping length warnings on System 5

Large 5-port condensers draw higher maximum current and sit heavier on concrete ledges. Before ordering a System 5 for an older resale HDB flat, confirm whether the flat carries 40A electrical loading rather than an older 30A circuit that can trip under full load.

Long piping runs across a large flat also reduce delivered cooling capacity slightly. Keeping the heaviest-use living-room fan coil on shorter pipe runs helps maintain stronger throw.

How to decide between System 4, System 5 and System 3+2

Stick to System 4 if four zones cover your daily rooms cleanly, because every connected room gets a bigger share of compressor output. Choose System 5 only if you genuinely need five indoor heads on one restricted ledge and accept staggered room usage. Choose System 3+2 wherever dual condensers fit legally and physically.

Snowflake Aircon Services checks simultaneous load ratios, ledge size and DB electrical capacity before quoting any System 5 installation.

Common questions

Can a System 5 aircon cool all five rooms at the same time in Singapore?
A System 5 can run all five indoor units simultaneously, yet each room will cool more slowly in hot Singapore weather because five fan coils share an 8.3 to 9.1 kW outdoor condenser. System 5 works best when living zones run by day and bedrooms run at night.
Is System 3+2 better than a single System 5 aircon?
System 3+2 outperforms a single System 5 whenever your home has space and approval for two outdoor condensers. Two separate condensers eliminate capacity bottlenecks during simultaneous use and keep half your flat cool if one outdoor unit needs repair.
Can an HDB flat install a System 5 aircon?
Many newer 4-room and 5-room HDB flats with 40A electrical loading and sufficient concrete ledge clearance can support a System 5 outdoor unit. Older 30A resale flats must verify permitted electrical load and ledge dimensions before ordering a 5-port condenser.
What happens if a System 5 outdoor unit develops a gas leak?
Because all five indoor fan coils share one sealed refrigerant circuit on a System 5, a single flare leak or coil leak drops cooling performance across all five rooms together. Nitrogen pressure testing must isolate the exact leaking branch before recharging.

Sources