Skip to main content

Why Aircons Feel Cold at 24 Degrees yet Warm at 25 Degrees

A dramatic comfort drop between 24°C and 25°C happens because wall units measure return air near the ceiling rather than at bed level, combined with inverter low-load cut-out gaps and thermistor drift. One extra degree on the remote can trigger long compressor pauses that let bedroom humidity climb.

On this page

Why inverter low-load pauses amplify one degree of change

Every inverter compressor has a minimum cooling floor. Inside a compact 9 square metre BTO bedroom cooled by an oversized 12,000 BTU indoor unit, raising the target from 24°C to 25°C drops room heat load below that minimum output, forcing the outdoor unit to cycle completely off.

While cooling pauses, relative humidity climbs rapidly from 55% toward 72% even if a bedside thermometer only creeps up by 0.8°C. Human skin notices moisture instantly, making 25°C feel clammy while continuous gentle dehumidification at 24°C feels crisp.

Why inverter low-load pauses amplify one degree of change summary table
Root factorHow it tricks the indoor unitPractical correction
Ceiling return-air stratificationWarm stagnant air near pelmet or curtain box reads cooler/warmer than bedRaise fan speed from Quiet to Medium and angle louvers outward
Inverter cut-out hysteresisCompressor stays idle until room climbs 1.5°C above setpointPair 25°C with steady medium fan or low-speed ceiling fan
Drifted room thermistorAged sensor reports 23°C when actual intake air sits at 26°CTest ohm resistance and replace faulty room thermistor sensor

Thermistor drift and short-cycling inside tight alcoves

Indoor units sense room temperature through a small bead thermistor clipped beside the intake grille. Dust coats that tiny bulb over years of tropical use, or moisture gradually shifts its electrical resistance so the control board thinks the bedroom is already chilled.

Tight carpentry niches create the opposite illusion. When a deep curtain pelmet or wardrobe top bounces chilled discharge air straight back into the top intake, the thermistor reads artificially cold within three minutes and shuts cooling down before the lower half of the room dries out.

Testing airflow versus sensor accuracy before booking parts

Place a simple digital hygrometer beside your pillow and run the fan on fixed Medium instead of Auto for one night. Stronger air mixing breaks up ceiling pockets and often makes 25°C feel comfortable without burning extra SP Group electricity.

If the aircon still cuts off when the bedside reading sits above 27°C, a technician can measure the room and coil thermistors against manufacturer resistance tables and check indoor blower speed. Swapping a drifted sensor restores predictable temperature control without replacing the full circuit board.

Common questions

Why does 25°C feel comfortable with a ceiling fan but muggy on its own?
Air movement across skin speeds sweat evaporation and mixes cool air trapped near the floor with warmer ceiling layers. Without mixing, an aircon cycling off at 25°C lets stagnant humid air pool around the bed, making the room feel two to three degrees warmer than the thermometer reads.
How do technicians confirm whether a room thermistor has drifted?
Technicians unplug the indoor room sensor harness and measure its electrical resistance with a digital multimeter beside a calibrated reference thermometer. When readings fall outside the brand resistance table at ambient temperature, swapping the drifted thermistor assembly restores accurate cooling cut-off behaviour.
Does setting fan speed to Auto make the 24°C to 25°C gap worse?
Auto fan slows the blower sharply as the room approaches setpoint, reducing air circulation across the bedroom. Slower airflow allows cold air to short-circuit around the indoor unit intake, convincing the thermistor to stop cooling earlier and leaving corners damp and warm.

Sources