Skip to main content

Aircon Piping Replacement Cost, and When Old Piping Must Go

Old copper piping often looks sound, which is why reuse is tempting. A new run is priced by length and by whether it is hidden, and the old pipe's condition decides whether you need one at all.

On this page

What new aircon piping costs

Operators price extra length per metre past the run they include, and quote the run itself by its length and how it is hidden. Concealed runs cost more than exposed ones.

Check how long a run each quote includes. Operators set that allowance differently, so two per-unit prices can cover very different lengths.

Aircon piping replacement cost
Piping jobMarket range in SingaporeOur rate
Piping run replaced, one indoor unitOnly two operators publish a per-run price, for different lengths; the run's length and concealment set it.Quoted per job
Extra piping beyond the included length$15–$120 per metre
Whole system re-piped, System 2 to System 4Only two operators publish a whole-system price; the number of runs and how much is concealed set it.
New trunking along the routeFewer than three operators price trunking per metre; exposed or concealed trunking sets it.Quoted per job

An exposed run costs least. A run concealed in a wall or false ceiling costs more, and operators include different lengths before charging per metre.

Market ranges: published rates from 5 Singapore operators. Checked 20 Nov 2026.

Our rates are from our rate card.

Keep or replace: a checklist

Old piping can stay only if it passes every check. A single failure is enough to replace it.

Keep or replace: a checklist summary table
CheckKeep it ifReplace it if
Pipe size and wall gaugeThey suit the new unit's manualThey are smaller or thinner than specified
Flare jointsRemade to suit the new refrigerantOld flares left as they are
Pressure testHolds with no dropPressure falls during the hold
Oil inside the old pipeCleanDark oil, or the old compressor failed
InsulationWhole and dryCracked, wet or with rust underneath
RouteSame rooms, same unit positionsUnits are moving or the layout changes

Why concealed piping costs more

Concealed piping runs inside a wall, a false ceiling or a boxed-up trunk. Replacing it means cutting into that finish and patching it afterwards.

Before a renovation closes a wall, ask whether the piping in it is new and tested. Replacing it later costs more than doing it while the wall is open.

When the piping question comes up

Each of these is a chance to test the old run before deciding. A pressure test answers whether it leaks; the other checks answer whether it suits the new unit.

  • Replacing an old system, especially one on R22.
  • A gas leak traced to a section of pipe rather than a joint.
  • A renovation that moves the indoor or outdoor unit.
  • Insulation that has cracked or is dripping along the trunking.

Common questions

How much does aircon piping replacement cost in Singapore?
Operators in Singapore quote a replacement piping run by its length and how it is concealed, then charge per metre beyond the length they include. An exposed run costs least. A run hidden in a wall or false ceiling costs more, because the finish must be cut open and patched afterwards.
Can old aircon piping be reused with a new aircon?
Yes, when it passes every check. The pipe size and wall gauge must suit the new unit's installation manual, the run must hold a pressure test, the oil inside must be clean and the insulation sound. If any check fails, or the units are moving, replace the piping with the new system.
Does old aircon copper piping need replacing because of its age?
Age alone does not decide whether aircon copper piping can stay in service. A leak, damaged insulation, contamination from a failed compressor, or a size mismatch with the new unit are the reasons old piping has to go. A pressure test and a check of the insulation and oil show which applies.
Why is concealed aircon piping more expensive to replace?
Concealed aircon piping sits inside a wall, a false ceiling or boxed trunking, so replacing it means cutting into that finish and patching it afterwards. Exposed piping in trunking can be swapped without that work. The concealment and the patching, not the copper, add most of the extra cost.

Sources