Skip to main content

Aircon Placement Near a Curtain Pelmet: Clearance Rules

Leave at least 150 mm of side clearance and 100 to 150 mm of top clearance between a wall-mounted aircon and any curtain pelmet or blackout drapery. Crowding a pelmet traps chilled air against fabric, triggers damp curtain mould and prevents technicians from opening the indoor casing.

On this page

Minimum clearances to mark on renovation drawings

Built-in curtain pelmets look sleek in modern Singapore BTO and condo bedrooms, yet carpenters frequently extend the pelmet right into the corner where the aircon sits. Once the gypsum box or timber pelmet crowds the fan coil, airflow and servicing access both suffer.

Agree on exact clearance numbers between your interior designer and aircon installer during Trip 1 piping.

Minimum clearances to mark on renovation drawings summary table
Clearance zoneRecommended minimumWhat goes wrong if cramped
Side gap to curtain pelmet / track150 mm to 200 mmBlackout curtains blow sideways, block return air and wick cold moisture
Top intake gap to ceiling / pelmet lip100 mm to 150 mmChoked top return grille raises fan noise and lowers cooling output
Bottom edge above window frame or sillKeep full front casing clear of pelmet overhangFront cover cannot swing upward to remove filters or drain pan
Front throw clear of sheer curtainsAt least 300 mm clear swing pathCold air bounces off heavy drapes back into thermostat sensor

Why curtains near an aircon grow mould and cause short-cycling

When an indoor fan coil blows sideways across a thick night curtain, chilled air strikes the fabric and rebounds straight back into the unit's top temperature thermistor. The aircon reads the room as cold too early and cycles down while the far side of the bedroom stays warm.

Repeated blasts of cold air onto warm window glass behind the curtain also raise local condensation, encouraging dark mildew patches along the upper curtain header.

Practical fixes if the pelmet is already built

If your curtain pelmet already extends close to the aircon wall, stop the curtain track 200 mm short of the indoor unit edge or install a recessed roller blind on that outer window pane instead of pleated fabric drapes. Aim the inner vertical aircon vanes away from the window side.

Always check that a technician can still unclip the entire front cover and slide a wash canvas safely underneath during servicing.

Common questions

Can I install a wall aircon directly underneath a built-in curtain pelmet?
Mounting a wall aircon tightly under a deep curtain pelmet is poor practice because the overhanging box blocks top return airflow and traps cold supply air. Leave at least 150 mm vertical clearance below any overhang and ensure curtains never brush the aircon casing.
How far from a bedroom window curtain should the side of an aircon sit?
Position the side of the wall-mounted aircon at least 150 mm to 200 mm clear of stacked open curtains and curtain tracks. That buffer prevents fabric from billowing into the airstream, stops mildew from damp condensation and leaves enough room to unclip the casing.
Why does my bedroom aircon keep turning off early when I draw the blackout curtains?
Heavy curtains brushing close to the aircon outlet deflect chilly supply air straight back upward into the unit's return temperature sensor. The indoor PCB thinks the entire bedroom reached setpoint and slows the compressor prematurely while the rest of the room stays warm.
Are roller blinds or day-night curtains better near a tight HDB aircon corner?
Recessed roller blinds or combi blinds sit flat inside the window frame with zero bulky fabric stack, making them far easier to pair with a corner-mounted HDB aircon than wide pleated curtains that spill out sideways into the aircon's clearance zone.

Sources