Skip to main content

Centralised Aircon Controller Faults: Repair or Replace It

When a wall or central controller stops working, the fault is often not the controller. Wiring, the indoor unit's board or the communication line can all make a good controller look dead.

On this page

Repair or replace a failed controller?

Test before replacing. A blank or frozen controller is often a wiring, power or communication fault, or a board in the indoor unit, rather than the controller itself.

Replace the controller when it is confirmed faulty and a compatible model is supplied. Controllers are replaced as a unit, not repaired at board level.

Controller faults: what each fix involves
FixMarket range in SingaporeOur rate
Wired wall controller replacedNo published controller price was found; the model and whether it is still supplied set it.
Central controller for several units replacedNo published price was found; the controller model and the number of units it runs set it.
Wiring or communication line repairedQuoted after testing; the cable run and access set it.Quoted per job
Diagnostic visit to find the cause$30 / visit

A controller still supplied for the system is a short job. An older central controller may need a newer model that the system's maker confirms is compatible.

Our rates are from our rate card.

Signs that point away from the controller

Note any code on the screen before calling. It usually names the unit and the fault.

  • Several controllers fail at once: the power or communication line.
  • The controller shows an error code: the indoor or outdoor unit has a fault.
  • The controller works but one unit ignores it: that unit's board or address.
  • The screen is blank after a power trip: the supply to the controller.

When the whole controller set should be upgraded

On an older multi-unit system, a failed central controller may no longer be made. A newer controller can sometimes run the old units, but only the maker's compatibility list confirms it.

If the indoor units are also old, price the controller beside a wider replacement.

Central controllers mostly run VRF systems. Of the VRF brands, Snowflake repairs only Daikin VRV.

Common questions

Can a centralised aircon controller be repaired?
A faulty centralised aircon controller is normally replaced as a unit rather than repaired at board level. Before replacing it, the wiring, power supply and communication line should be tested, because those faults make a working controller look dead and cost less to fix.
Why is my aircon wall controller blank?
A blank aircon wall controller usually has no power or has lost its link to the indoor unit, often after a trip or a loose wire. It can also be the indoor unit's board or the controller itself. A technician tests the supply and wiring first, before replacing anything.
Will a new controller work with my old aircon system?
Only if the system's maker lists it as compatible. On older multi-unit systems the original central controller may no longer be made, and a newer model can sometimes run the old units. The maker's compatibility list, not the brand name alone, decides whether it will.
What does an error code on the controller mean?
An error code on an aircon controller usually reports a fault in an indoor or outdoor unit, such as a sensor, drain or communication problem, rather than in the controller itself. Note the code and the unit it names before calling, because it points the technician to the right part.