Skip to main content

Daikin E1, E3 and E4 Faults: Pressure and Outdoor Boards

Daikin E1 signals a circuit board fault, E3 indicates actuation of the high pressure switch, and E4 marks actuation of the low pressure switch. Separating outdoor electronics from refrigerant pressure protection stops unnecessary board replacements on Singapore HDB and condo condensers.

On this page

Verified Daikin E1, E3 and E4 fault definitions

Hold the Cancel button on a Daikin wireless handset to scroll through stored diagnostic codes until a steady long beep confirms the active fault. While E1 points directly to electronic control hardware, both E3 and E4 are mechanical or refrigerant-side safety cutoffs designed to shield the compressor.

Confusing a blocked condenser coil with a dead circuit board wastes repair money. Technicians verify outdoor fan airflow, service valve positions, and manifold pressures before approving any major component replacement.

Verified Daikin E1, E3 and E4 fault definitions summary table
CodeFault categoryVerified Daikin meaning and field check
E1PCB / Electrical FaultCircuit board fault: inspect power stability and replace the failed outdoor PCB as a complete assembly.
E3Refrigerant / Pressure FaultActuation of high pressure switch: check choked condenser fins, stalled outdoor fan, overcharge, or closed service valves.
E4Refrigerant / Pressure FaultActuation of low pressure switch: pressure-test copper joints for refrigerant loss and check indoor coil blockage.

Why high and low pressure switches trip on Singapore ledges

Enclosed BTO aircon ledges and dusty west-facing balconies trap hot exhaust air around multi-split condensers such as the MKM85VVMG or MKM100ZVMG. When greasy lint blankets the outdoor aluminium fins, head pressure climbs quickly until the E3 high pressure switch halts compressor operation.

Conversely, E4 triggers when suction pressure drops below safe operating thresholds. Gradual flare-nut seepage along trunking bends, a partially shut liquid valve, or a restricted expansion path starves the evaporator until the low pressure switch opens.

Safe diagnostic steps before replacing an outdoor board

Leave wall isolators untouched and do not toggle tripped circuit breakers to clear E1, E3, or E4 warnings. Repeated startups under abnormal pressure or electrical stress can seize an inverter compressor.

When live diagnostic readings confirm an E1 circuit board fault, the outdoor PCB must be swapped as a whole original module rather than patched by soldering. For E3 and E4, flushing the condenser, verifying switch continuity, and pressure-testing for leaks restore reliable cooling.

Common questions

Can a dirty outdoor condenser coil trigger Daikin error code E3?
Blocked outdoor condenser fins frequently trigger Daikin E3 by trapping heat and driving discharge pressure above the high pressure switch threshold. Technicians clean the outdoor coil, confirm strong condenser fan airflow, verify service valves stay fully open, and check operating refrigerant pressures before blaming the switch itself.
Does Daikin error E1 require full outdoor board replacement?
Confirmed Daikin E1 circuit board faults require replacing the complete outdoor PCB assembly rather than attempting component-level soldering. Technicians first inspect incoming supply voltage, loose terminal blocks, and corroded wire harnesses so a simple wiring fault is excluded before installing a genuine replacement control board.
What causes Daikin E4 low pressure switch actuation in HDB flats?
Refrigerant leaks at aged flare joints, closed isolation valves after prior works, or severe evaporator airflow blockage commonly cause Daikin E4 low pressure switch actuation. Proper repair involves nitrogen pressure testing, fixing the leak point, pulling a deep vacuum, and weighing in fresh refrigerant accurately.

Sources

Sources checked .

  1. Daikin Singapore
  2. Daikin Warranty Terms