On this page
Should you keep running an aircon with a gas leak?
Book a leak check and run the aircon as little as possible until it is done. Ice, a hiss, oily residue or a self-stop mean leave it off now.
The documented harm is to the compressor. Mitsubishi Heavy Industries' Singapore FAQ states that an unrepaired leak may cause premature compressor failure.
| What you notice | Until the leak check | Why |
|---|---|---|
| Cooling weaker over weeks, nothing else | Use it as little as possible | The charge is falling and the compressor is running hot |
| Ice on the copper pipe or indoor unit | Leave it off and let it thaw | Ice blocks the coil, so it cools nothing and melts into a drip |
| A new hiss at a joint, or oily residue on the pipe | Leave it off | The leak is active, and running adds to the loss |
| The unit stops itself or shows a code | Leave it off and note the code | A protection stop means the unit will not run safely in that state |
| Cooling faded again after a recent top-up | Use it as little as possible | The leak was never found, so the new gas is leaving too |
What a low charge does to the compressor
Less refrigerant in circulation means lower suction pressure. Copeland, the compressor maker, lists low suction pressure as a cause of overheating.
Overheating breaks down the compressor's oil. Copeland states that oil heated far enough loses its ability to lubricate.
A leak found early is usually a joint or a valve. A compressor that ran hot for months turns the same leak into a compressor decision.
When the gas itself is a safety matter
The model sticker names the refrigerant. For R32, Daikin states the ISO 817 class is A2L, meaning mildly flammable, and safe in a properly designed system.
A sudden, loud release indoors is different from a slow seep outside. Switch the unit off at the remote, open the windows and keep flames away until it has been checked.
Why ice means switch off
Ice is the sign most often ignored. A frozen coil passes almost no air, so the room stays warm.
Switching off lets the coil thaw. Left running, the meltwater can overflow the drain tray, and a gas fault becomes a water leak on the wall.
Why a top-up does not make it safe to use
A top-up buys cooling only until the new charge escapes. Mitsubishi Electric's FAQ rules this out: it calls for a pressure test and a repair, then the correct charge.
The companion guide sets out the gas leak repair steps in full. To book, ask for gas leak detection rather than a top-up.