Skip to main content

LG Aircon Will Not Turn On: Safe Checks and Board Faults

An unresponsive LG split aircon in Singapore usually traces to dead remote batteries, a tripped breaker or a failed indoor or outdoor PCB. Check the remote and manual indoor button first, and never force a tripped circuit breaker back on without inspection.

On this page

Separating handset issues from genuine LG power faults

A silent indoor wall unit with zero beep or indicator light falls into three buckets: a dead remote control, lost incoming power at the wall isolator or distribution board, or a failed indoor receiver or main control PCB.

Running two zero-tool surface checks takes one minute and tells you immediately whether a technician is needed.

Separating handset issues from genuine LG power faults summary table
Safe surface checkWhat result meansNext action
Point remote at phone camera & press PowerNo faint purple flash on camera with fresh AAA batteriesRemote control is dead; replace batteries or handset
Press indoor manual ON/OFF button gently (under front lid)Unit starts blowing cold normally, remote still ignoredFaulty remote or failed indoor IR receiver eye
Check wall isolator red LED & DB breaker visuallyAircon MCB or ELCB has tripped downDo NOT flip breaker back repeatedly; book electrical fault diagnosis
Isolator lit, manual button dead across one or all roomsBlown internal fuse or failed indoor/outdoor control PCBBook technician diagnosis; failed PCBs are replaced, not repaired

Why you must never keep resetting a tripped aircon breaker

If the dedicated aircon circuit breaker or ELCB inside your HDB or condo distribution box sits in the off position, a short circuit, water-damaged outdoor board or compressor insulation fault caused it to trip for safety.

Forcing a tripped breaker back up risks electrical arcing, scorching wiring or destroying an otherwise salvageable indoor circuit board. Leave the circuit off and call a qualified technician or Licensed Electrical Worker.

Indoor vs outdoor PCB replacement on LG multi-splits

On an LG multi-split system, if every bedroom unit goes dead at once while the isolator still carries power, the fault commonly sits on the outdoor main inverter PCB supplying indoor communication power. If only one bedroom stays lifeless while other rooms cool normally, that room's indoor PCB or display sensor has failed.

At Snowflake Aircon Services, failed PCBs are always replaced with genuine replacement boards rather than patched with component-level board repairs, ensuring safe long-term operation.

Common questions

How do I test if my LG aircon remote or the wall unit is broken?
Install fresh alkaline AAA batteries, open your smartphone camera aimed at the remote's front bulb and press Power to look for a faint purple infrared flash. You can also press the indoor unit's built-in manual ON/OFF button gently; if cooling starts, the wall unit works.
Why did all my LG multi-split bedrooms stop turning on at the exact same time?
When every indoor fan coil on an LG multi-split goes completely dead simultaneously, incoming power from the wall isolator or outdoor inverter main PCB has been interrupted. Check visually whether the distribution board breaker tripped, leave any tripped breaker off and book diagnostic testing.
Can a failed LG aircon PCB be repaired instead of replaced in Singapore?
Snowflake Aircon Services replaces faulty aircon PCBs outright with proper replacement boards rather than attempting component-level PCB repairs. Moisture corrosion and power-surge damage inside multi-layer inverter boards make partial soldering unreliable and prone to repeat failures in humid Singapore flats.
Is an LG aircon that will not turn on covered under LG Singapore warranty?
Official LG Electronics Singapore warranty covers manufacturing defects in indoor and outdoor PCBs within the active general parts warranty window, usually one year from installation unless extended coverage applies. Power-surge damage, pest intrusion or water leaks from neglected servicing are excluded.

Sources