Skip to main content

Multi-Split Gas Leak: Why Every Room Loses Cooling at Once

On a System 3 or System 4, one leaking pipe can take every room's aircon off at the same time. The rooms share one outdoor unit and one charge of gas, and that sets how the repair has to run.

On this page

Why does the whole system stop?

A System 2, 3 or 4 runs every indoor unit from one outdoor unit and one refrigerant charge. A leak in any room's pipe drains the gas the other rooms share.

Testing has the same effect. To find the leak, the gas is usually recovered or pumped down and the pipes are filled with dry nitrogen, so the rooms cannot cool until the circuit is recharged.

Why does the whole system stop? summary table
StageWhich rooms are offWhat sets the time
Gas recovered from the systemAll roomsThe size of the charge
Nitrogen pressure testAll roomsHow long the pressure is held
Leak repairedAll roomsWhere the leak is and whether a part must be ordered
Vacuum and recharge by weightAll roomsThe charge for the whole system
Back in serviceNoneA final check in every room

How long the system is off

How long the nitrogen is held sets the test time, and the repair adds to it. Ask the technician for the hold time before the work starts.

A joint remade on the visit adds little. A coil or a pipe section that has to be ordered keeps every room off until it arrives.

Can the other rooms keep running?

Usually not. The gas is recovered and the pipes are tested as one system, so every room typically waits for the same recharge.

Switching off the leaking room alone does not help either. The gas still escapes, and the outdoor unit runs short of charge for every room.

Planning the days without aircon

A test that holds overnight needs the flat left as it is. Do not switch the aircon on while the circuit holds nitrogen.

  • Book the test for days the flat is least used, such as a work week.
  • Ask whether the leak test and the repair can be done in one booking.
  • Ask how long the nitrogen will be held, and why.
  • Keep fans ready for the bedrooms.
  • Ask for the test readings in writing before the system is recharged.

When a repeat leak points to replacement

A multi-split that needs repeated leak repairs costs every room its cooling each time. On an older system, compare the repair with a new system for the same rooms before the next test.

Common questions

Why does my System 3 aircon stop in every room when one room has a gas leak?
A System 3 aircon runs all three indoor units from one outdoor unit and one shared refrigerant charge. A leak in any room's piping drains gas the other rooms depend on, and the leak test empties the whole circuit, so every room stays off until the repair and the recharge are done.
How long is a multi-split aircon off during a gas leak test?
A multi-split aircon is usually off for the whole leak test, and how long the nitrogen is held sets that time. The repair and the recharge add to it, and a part that must be ordered extends it further. Ask the technician for the planned hold time before the work starts.
Can I keep using the other rooms while one multi-split unit is repaired?
Usually not. On a household multi-split, every indoor unit shares one refrigerant circuit, so the gas is recovered and the pipes are tested as one system. The other rooms cannot cool until the leak is repaired and the whole circuit is vacuumed and recharged, which is why the work is best planned around the days the flat is least used.
Is a multi-split worth repairing after repeated gas leaks?
Repeat leaks on an older multi-split are the point to price a new system for those rooms before booking the next test. Each gas leak repair on a multi-split takes every room's cooling off, so the cost of repeated downtime adds to the repair bills themselves.

Sources