On this page
Core steps inside a thorough general servicing visit
Every indoor fancoil unit accumulates fine lint, humid bedroom dust, and sticky drain jelly between quarterly appointments. Technicians should open or detach the front cover, wash removable filters and louvers in a bathroom basin, and brush or vacuum dry debris off the aluminium evaporator surface.
Drainage care separates preventive maintenance from quick cosmetic wipe-downs. Flushing or vacuuming the drainage outlet clears early algae buildup inside the condensate pan and discharge pipe before water backs up down painted HDB or condo walls.
| Servicing step | What gets cleaned or checked | Why skipping it hurts performance |
|---|---|---|
| Filters and front cover | Wash mesh filters, wipe housing and louver blades | Restricted intake raises electricity draw and dust odour |
| Evaporator coil face | Brush or vacuum surface lint, check fin alignment | Matted coils choke airflow and trigger coil icing |
| Blower wheel inspection | Check drum blades for furry mould or wobble | Caked blades slash throw distance and add vibration |
| Drain pan and pipe | Clear pan outlet and flush or wet-vacuum drain line | Jelly plugs cause indoor dripping within weeks |
| Operational check | Verify cold supply air, condensate flow, noise, amp draw | Early refrigerant loss or weak fan motors go unnoticed |
How to spot rushed visits and skipped steps
Watch how long a crew spends per indoor unit and what tools leave their bag. A five-minute stop involving only filter rinsing and a quick rag wipe leaves the drain outlet untouched and misses caked dirt packed inside the cylindrical blower drum.
Outdoor condenser inspection also matters when ledge access is safe and permitted. Checking outdoor airflow clearance, condenser coil dust load, and abnormal compressor sound helps catch heat-rejection bottlenecks that make every connected bedroom feel sluggish.
When general servicing is no longer enough
General servicing maintains clean systems on a regular three- to four-month rhythm, yet it cannot dissolve hardened mould baked deep between rear evaporator fins or inside a stubbornly blocked drain trough. Those conditions point toward chemical cleaning or full chemical overhaul.
Asking technicians to show you the blower wheel and evaporator condition with a torchlight before reassembly keeps maintenance honest. You immediately see whether routine dry cleaning solved the restriction or whether deeper dismantling is genuinely justified next visit.