On this page
How to open and slide out mesh filters by brand
Always turn the aircon off via the remote and switch off its wall isolator before standing on a sturdy step ladder. Never pull the front cover from the centre only; grip both left and right finger recesses evenly so the side hinges click upward without snapping.
Most Singapore residential splits place two large nylon mesh filters right behind the front lift panel, while select LG and Samsung models put a single top-mounted filter on top of the casing so you do not even lift the front lid.
| Brand | Where the filters sit | Key removal watchout |
|---|---|---|
| Daikin (iSmile / FTKM) | Two mesh filters behind front lift panel; push bottom tabs up and pull down | Separate the small titanium-apatite deodorising strip; never soak paper strips |
| Mitsubishi Electric Starmex | Two mesh filters behind front lift panel; lift tabs slightly and slide out | Close front panel firmly at both ends and centre until all clips click shut |
| Panasonic (XU / PU) | Two mesh filters behind front lift panel | Avoid touching sharp aluminum fins or the nanoe X emitter behind the panel |
| Samsung (WindFree / Easy Filter+) | Top-mounted Easy Filter Plus lifts straight off the upper intake grille | No front lid lifting needed; dry completely before clicking back on top |
| LG / Midea / PRISM+ | Top lift-out filter on newer LG Dual Inverter; front-panel filters on Midea/PRISM+ | Check user manual before pulling; never force stiff front hinge arms |
Correct washing and drying steps that protect the mesh
Rinse filters from the clean back side first using cool or lukewarm tap water so dust flushes off instead of pushing deeper into the weave. For kitchen-adjacent living rooms with light grease, gently swish with a few drops of mild dish soap and a soft brush.
Never use boiling water, stiff wire brushes or direct afternoon sunlight on an HDB balcony. Heat warps the thin plastic frame so it no longer slides smoothly back into the indoor rails.
- Switch off the unit and wall isolator before opening any panel.
- Rinse dust off from the back side with plain tap water or mild dish soap.
- Leave small carbon, catechin or electrostatic specialty strips dry unless the manual says washable.
- Air-dry mesh filters completely in the shade before sliding them back in.
When washing the filter is not enough
Mesh filters catch coarse lint and pet hair, yet microscopic grease, humid dust and fungal spores still pass through onto the wet evaporator fins and cylindrical blower wheel over months of daily Singapore operation.
If you shine a phone torch past the louvers and see fuzzy grey carpet on the blower drum or black spots inside the outlet, schedule professional servicing rather than poking brushes inside the spinning drum.
Keeping filter care on a reliable rhythm
Set a fortnightly calendar reminder for heavily used master bedrooms and pet homes, and a monthly wash for spare rooms. Clean filters alone noticeably restore airflow and delay drain chokes.
Snowflake Aircon Services pairs homeowner filter care with periodic general servicing that cleans the coil, blower wheel and drain line safely without bending fragile fins.