Daikin Aircon LC Error Code
Daikin LC points to transmission fault between control PCB and inverter PCB. The source is official, but the exact model or series still decides the applicable row.
What Does Daikin LC Mean?
Daikin LC is listed as transmission fault between control PCB and inverter PCB in Ceiling Cassette, Ceiling Suspended, Inverter Split rows such as General RA self-diagnosis guide, SkyAir. The loaded row is source-backed by official diagnostic material. Confirm the exact model, series, or signal row before accepting a parts quote.
Loose, corroded, crossed, or damaged indoor-outdoor signal wiring.
Terminal block, connector, or junction fault on the indoor or outdoor side.
Indoor or outdoor PCB communication circuit fault after wiring is proven sound.
What To Do Now
Use these steps before another reset, signal-wire check, or PCB quote.
Stop using the unit if LC returns
If LC returns after one reset, stop repeated restarts and get the matching source row diagnosed.
Reset LC once
Capture the LC display first, then power-cycle once only and note whether the same fault returns.
Send these to us
LC error code, a clear display photo, Daikin model stickers, affected rooms, reset result, and whether one room or every room failed
Send Us What You're Seeing
Share LC, your Daikin model, and what happened before it appeared. We'll read it and respond with the right next step before any work is approved.
What To Check Before Repair
Use this split to separate safe evidence capture from the tests a technician should prove before quoting parts.
| You Can Check | Technician Should Confirm |
|---|---|
| Before resetting LC, take a clear display photo. | Match LC against the exact model-family source row before quoting parts. |
| Capture the Daikin indoor and outdoor model stickers so the correct family row is used. | Test communication terminals, cable continuity, polarity, and outdoor power. |
| Note whether one room, several rooms, or the whole system is affected, plus whether it returns after one reset. | Read indoor and outdoor PCB indicators only after the signal path is proven sound. |
What Changes The Next Step
These clues decide whether the first check is room-side, shared outdoor-side, refrigerant-side, source-table, or model-family confirmation.
| What You See | What It Points To |
|---|---|
| Only one indoor unit shows LC. | The affected room, indoor board path, wiring route, or local component should be checked first. |
| Several rooms or the outdoor unit show the same LC fault. | The shared outdoor side, power path, communication trunk, or refrigerant circuit needs priority checking. |
| The fault returns immediately after one reset. | Start with the source-row diagnostic branch before approving parts. |
| The model family is different from the row you found online. | Use the model or series filter first; same-looking codes can still belong to different diagnostic tables. |
| The model belongs to Ceiling Cassette, Ceiling Suspended, Inverter Split rows such as General RA self-diagnosis guide, SkyAir. | The loaded row is source-backed by official diagnostic material. Use the matching source row before quoting parts. |
Wiring Or PCB Decision
Daikin LC should start with terminal, signal-cable, and power checks. PCB replacement only makes sense after the communication path is proven sound.
A loose terminal or bad junction is a targeted repair once the path is confirmed.
Signal-wire replacement depends mostly on access through trunking, ceiling, or concealed routes.
PCB cost should be weighed against age only after wiring and power checks pass.
Read Next
Use these if the quote mentions the parts, checks, or repair path this code points to.
Other Daikin Error Codes
If the code you're seeing isn't LC, jump to one of these or browse the full Daikin list.
Ready to Get Started?
Send the LC error code, a clear display photo, and Daikin model sticker. Send the model sticker so the matching official row can be checked quickly. We can help separate wiring, terminal, and PCB checks.