On this page
How the dropped switch narrows down the electrical fault
Every Singapore HDB or condo distribution box separates earth-leakage protection from branch overcurrent protection. When the wide ELCB or RCCB lever drops and cuts power across multiple sockets and lights, tiny stray current has escaped into the metal chassis or earth wire.
When only the single narrow MCB labelled Aircon drops while household lights stay bright, the aircon circuit drew a massive surge of amps far above its 15A or 20A rating. That distinction guides technicians straight to the right diagnostic meter test.
| Tripped switch in box | Electrical fault type | Common aircon root causes |
|---|---|---|
| Wide ELCB or RCCB drops whole flat | Current leaking to earth | Water inside PCB, damp outdoor isolator, grounded motor |
| Single Aircon MCB drops instantly | Direct short circuit | Burnt compressor windings or shorted inverter PCB |
| Single Aircon MCB drops after 10 minutes | Sustained amp overload | Seizing compressor, choked condenser, weak capacitor |
| Both ELCB and MCB trip together | Severe live-to-earth fault | Chewed outdoor cable or catastrophic outdoor board burn |
Why you must never keep flipping a tripped breaker back on
Never force a tripped ELCB or MCB back upward repeatedly hoping the aircon will hold. Protective switches drop specifically to halt electric shock hazards and prevent hidden wall wiring or burnt compressors from igniting inside enclosed trunking.
Leave the dedicated aircon wall isolator switched off if the circuit has tripped even once. Do not open the outdoor condenser cover or indoor electrical box yourself, as high-voltage DC capacitors on inverter PCBs retain dangerous charge even after power disconnects.
How technicians trace earth leakage and compressor shorts safely
Using an insulation resistance tester, technicians isolate the indoor FCU, interconnecting control cable, and outdoor compressor windings one branch at a time with power completely disconnected. That pinpoints whether rain seeped into a ledge isolator or a compressor winding broke down to earth.
If moisture or surge damage ruined an indoor or outdoor control board, the entire PCB is replaced with a genuine assembly rather than repaired on site. Separate fixed-wiring faults inside the household distribution box itself require an EMA-licensed electrical worker.