On this page
Why won't my Daikin aircon turn on?
Daikin's operation manual for its FTX25KM and FTX35KM wall units, a European range, gives four checks when the unit does not operate and the operation lamp is off. A breaker is off or a fuse has blown, the power has failed, the remote has no batteries, or the timer is wrong.
What the operation lamp does narrows it further. Daikin separates a dead unit with the lamp off from one that stopped with the lamp on, and from one whose lamp is flashing.
| What you see | What Daikin's manual says | Next step |
|---|---|---|
| Operation lamp off, no response | Check the breaker or fuse, a power failure, remote batteries and the timer | Owner checks below; a tripped breaker stays off |
| Remote display faint or blank | The batteries are dying | Replace both AAA batteries together |
| Stopped after a power cut | Resumes by itself in about 3 minutes | Wait before calling |
| Stopped suddenly, operation lamp on | A large voltage swing stops it; resumes in about 3 minutes | Wait; repeated stops need a supply test |
| Stopped, operation lamp flashing | Daikin lists filters and blocked inlets first; call the service shop if it keeps flashing | Read the code, then book |
| Breaker, fuse or earth leakage breaker cuts off often | Call the service shop | Leave it off and book |
What a Daikin owner can check safely
Start with the remote. Daikin Singapore blames a missed signal on flat batteries, a blocked receiver on the indoor unit or standing too far away. A daikin remote not responding can also be taken to Daikin's spare parts centre for checking.
Daikin's manual says a faint or blank remote display means the batteries are dying, and both AAA batteries go in new together. Changing them also wipes any ON or OFF timer from memory.
Timers matter more than they look. The manual says to set the timer again after a breaker trip, a power failure or a battery change. A forgotten timer can leave the unit idle.
Then look at the distribution board without touching it. If the aircon breaker or isolator has tripped, leave it off and book a check. The general page on an aircon cannot turn on covers the circuit side. A unit found dead after a service visit has its own page.
Keep it off or book: what a technician tests
Daikin's manual lists the signs that mean stop, turn the breaker off and call the service shop. They are a burning smell, a hot or damaged power cord, and a breaker, fuse or earth leakage breaker that keeps cutting out. It also says not to repair or modify the unit yourself.
A technician measures the supply from the breaker to the unit terminals before suspecting a part. Daikin's SM-TS3 code table then narrows the rest: U2 covers abnormal supply voltage or an instantaneous power failure.
U4 is a break in the indoor and outdoor link. Its causes include wiring faults, outdoor power switched off and a defective board. A1 points to the indoor board. A flashing lamp holds one of these codes, and the daikin blinking light guide shows how to read it.
Snowflake Aircon Services replaces a failed board rather than repairing it. The board is condemned only once the supply, fuse and wiring have tested clean.