Skip to main content

Mitsubishi Electric Starmex Not Cooling: Causes and Repair

A Starmex that blows air but fails to cool usually has one of a few causes. Mitsubishi Electric's own advice points first to refrigerant and servicing.

On this page

Why is my Starmex not cooling?

Mitsubishi Electric names insufficient refrigerant or a lack of servicing as the usual reasons. Low refrigerant means the unit was undercharged at installation or is leaking, and adding gas does not fix a leak.

Dirty filters, a fouled coil or a blocked outdoor unit cut cooling too, and they are the cheapest to fix.

Why is my Starmex not cooling? summary table
CauseSignFix
Dirty filters or coilWeak airflow, musty smellServicing or a chemical wash
Refrigerant leakCooling fades over weeks; ice on pipesPressure test, repair, then recharge
Outdoor unit blocked or dirtyOutdoor fan runs, little coolingA technician clears and washes the outdoor coil
Fan motor or sensor faultFan slow or stopping; unit stops earlyDiagnosis and part replacement
Board or compressor faultOutdoor unit silent, or a code shownBoard replaced; compressor repaired or system replaced

What to check before calling

Do not open the unit or top up gas yourself. A refrigerant leak needs a pressure test to find it.

  • The mode is set to cool and the temperature is set low enough.
  • Windows and doors are closed.
  • Seen from a window, nothing seems to sit against the outdoor unit; stay off the ledge.
  • The date of the last filter cleaning at a servicing.

Why a top-up is not the repair

Mitsubishi Electric's guidance is to locate the leak with a pressure test, repair it, then recharge to the correct amount. A top-up without the repair puts gas into a circuit that keeps leaking.

Starmex is the brand Snowflake Aircon Services fits by default, so its parts and fault codes are familiar.

Common questions

Why is my Mitsubishi Electric aircon running but not cold?
Mitsubishi Electric names insufficient refrigerant or a lack of servicing as the usual causes. Low refrigerant means an undercharge at installation or a leak. Dirty filters, a fouled coil or a blocked outdoor unit also cut cooling, and a fan motor, sensor or board fault can stop it.
Does a Mitsubishi Electric aircon need a gas top-up when it is not cold?
Not on its own. If a Mitsubishi Electric aircon is low on refrigerant, it has been undercharged or it is leaking. Mitsubishi Electric's guidance is to find the leak with a pressure test, repair it and then recharge to the correct amount, rather than topping up.
Can dirty filters stop a Starmex from cooling?
Yes. Dirty filters, a fouled cooling coil or a clogged fan cut the airflow across a Starmex indoor unit, so less heat is removed and the room stays warm. Regular servicing clears them; if cooling stays weak afterwards, the cause is likely refrigerant or a part fault.
What does an error code on a Starmex mean?
An error code on a Mitsubishi Electric Starmex points to the part or circuit the unit has detected a fault in, such as a sensor, the fan, the outdoor unit or communication between units. Note the code and the blink pattern before calling, because it narrows what the technician tests.

Sources