Skip to main content

Office Aircon Not Cooling: A Fault or an Undersized System

An office that turns warm by mid-afternoon has either a system that has lost capacity or one that never had enough. The fix for each is different, so the first job is telling them apart.

On this page

Fault or undersized: how to tell

A fault shows as a change: the same office cooled well before and now does not. An undersized system shows as a pattern: it has always struggled on busy, hot afternoons, or since more people or equipment moved in.

The table sets out the signs that separate them.

Fault or undersized: how to tell summary table
SignPoints to a faultPoints to undersizing
When it startedRecently, after cooling wellFrom the start, or after the office changed
Air from the grillesWeak or not very coldCold, but the room still warms up
Units runningCycling off, icing or showing codesRunning flat out all afternoon
Which areasOne unit's zoneThe whole office, worst near windows or equipment
After servicingImproves if the cause was dirtNo change

Common faults that look like too little capacity

These are cheaper to fix than adding capacity, so a diagnosis comes first.

  • Dirty filters, coils or blowers cutting airflow.
  • Gas lost through a leak, so the units cool less.
  • An outdoor unit choked by dust or with blocked airflow.
  • A failed fan motor or sensor in one unit.

When the system really is too small

Office layouts change: more desks, more screens, a new pantry or server cupboard. Each adds heat the original system was not sized for.

For large building works, BCA's code says air-conditioning should be rightly sized for its cooling load. In any office, a heat-load check against the installed capacity shows whether the system can keep up.

What to ask for

Snowflake Aircon Services diagnoses each unit before quoting for added capacity.

  • A diagnosis of each unit before any capacity is added.
  • Airflow and supply-air temperature at the grilles.
  • A heat-load estimate if the units are working normally but cannot keep up.
  • Options: add a unit, replace with larger units, or shift heat sources such as a server cupboard.

Common questions

Why is my office aircon not cold enough in the afternoon?
An office aircon that cannot keep up in the afternoon is either faulty or too small for the heat load. A fault shows as a recent change, weak or warm air and units cycling or showing codes. An undersized system blows cold air but runs flat out and never catches up on hot, busy days.
How do I know if my office aircon is undersized?
An office aircon is likely undersized if it has always struggled, or started struggling after more people or equipment moved in, while the units blow cold air and run flat out. A diagnosis first rules out faults, then a heat-load estimate shows whether the installed capacity can match the room.
Will servicing fix an office aircon that is not cooling?
It will if dirt is the cause. Dirty filters, coils or blowers cut airflow and cooling, and a proper service restores them. If the office is still warm after servicing, the cause is a fault such as a gas leak, or a system too small for the heat load, and needs diagnosis.
What adds heat load to an office?
People, computers and screens, lighting, printers, pantry appliances, server equipment and sun through the windows all add heat load to an office. An aircon sized for the original layout can fall short when desks are added or a server cupboard is fitted without extra cooling.

Sources