Skip to main content

Toshiba Aircon Not Cold: Causes, Check Codes and Repair

A Toshiba aircon that runs without cooling has either a setting, filter or airflow problem, or trouble with its gas circuit, a sensor or the compressor. Toshiba's check codes separate the circuit faults before any part is quoted.

On this page

Why is my Toshiba aircon not cold?

Toshiba Singapore's own checks come first: cooling mode selected, a set temperature below the room, a clean air filter and closed windows and doors. An outdoor unit that is covered or crowded by an obstacle also cools poorly.

With those in order, the cause lies in the gas circuit, a temperature sensor or the compressor. Toshiba's check codes show which. The general aircon not cold page covers the causes shared by every brand.

Why is my Toshiba aircon not cold? summary table
CauseToshiba code or signWhat fixes it
Dusty filter or blocked outdoor unitWeak or warm air, no codeFilter cleaning, servicing, clearing the airflow
Wrong mode or settingFan runs, room stays warmCooling mode, set temperature below the room
Refrigerant or pressure fault25, 21 or 1ELeak and pressure tests, then repair
Temperature sensor fault0D, 18 or 19Sensor test and replacement
Compressor fault1D or 1FCompressor and drive tests, then the repair decision

Which Toshiba check codes point to gas, sensor or compressor faults?

Toshiba's check-code table for its residential room air conditioners names three groups that stop or weaken cooling. Code 25 is refrigerant leak detection, 21 is high pressure detected, and 1E is a discharge pipe temperature over its limit.

Code 0E is a fault in the leak sensor itself, not proof of a leak. The sensor codes are 0D for the indoor heat exchanger, 18 for the outdoor heat exchanger or suction pipe, and 19 for the discharge pipe.

Two codes name the compressor: 1D, compressor does not rotate, and 1F, compressor breakdown. Each code points a technician at a circuit; measurement confirms the part. The toshiba blinking light guide explains how to read the code from the remote.

What to check before calling a technician

A short pause after switching on is normal. Toshiba says the compressor can take three to five minutes to start running.

Toshiba advises checking and cleaning the air filter at least once every two weeks. A filter thick with dust cuts cooling on its own.

Look for covers, stored items or plants against the outdoor unit, but do not climb onto the ledge to reach it. Leave the casing closed and the gas alone. A refrigerant code calls for leak detection, and a recharge follows only after the repair holds pressure.

A unit that has never cooled well since installation may have a piping problem. Toshiba notes that cooling drops when the connecting pipe exceeds the maximum allowable length.

Repair or replace a Toshiba that has stopped cooling

Toshiba's Singapore warranty sets the first part of the sum. Its parts term is a year from installation, with a further quarter added by online registration inside a fortnight of the install.

Compressors can carry 48 months, but only on some models. The terms leave out the labour of taking off and fitting a part, and they leave out refrigerant too, so a covered compressor job still bills both. Registration steps and the void conditions sit in the toshiba aircon warranty guide.

Snowflake Aircon Services treats sensor faults and a sealed joint leak as worth repairing, and replaces failed boards rather than repairing them. A compressor fault outside its cover is priced against a new system. The diagnostic visit is where the check code gets confirmed against the unit.

A diagnostic visit confirms which fault applies before any quote is given.

Common questions

Why is my Toshiba aircon running but not cold?
Toshiba Singapore lists the mode not set to cooling, a set temperature above the room, a dusty air filter, open windows or doors and a covered outdoor unit. With those ruled out, the likely cause is the gas circuit, a temperature sensor or the compressor, and a check code narrows it.
Which Toshiba error code means a refrigerant leak?
Code 25 is refrigerant leak detection in Toshiba's residential check-code table, while 0E is a fault in the leak sensor itself. Codes 21, high pressure, and 1E, discharge temperature over limit, also involve the refrigerant circuit, so the system is tested for a leak before any gas goes in.
Does Toshiba's warranty cover a compressor that stops cooling?
Toshiba Singapore offers a 48-month compressor term on some models, longer than the base year of parts cover and its three-month registration bonus. Labour for swapping the part is excluded, as is refrigerant, so even a compressor replaced under that term leaves the owner paying for the work and the new charge.
Is a Toshiba aircon worth repairing when it is not cold?
A Toshiba with a sensor fault or a sealable joint leak is generally worth repairing, and a failed board is replaced with a new one. A compressor failure outside the warranty is better weighed against a replacement serving those rooms, since the coils, fan motors and board are equally old.

Sources