Skip to main content

LG CH22, CH29 and CH67 Overcurrent and Fan Fault Guide

LG CH22 signals a CT2 alternating current input overcurrent fault, CH29 indicates excessive inverter compressor amperage, and CH67 flags an outdoor fan error. Measuring live draw and airflow restrictions separates clogged Singapore condensers from failed motors or outdoor boards.

On this page

Verified LG CH22, CH29 and CH67 fault meanings

LG multi-split condensers such as the Z4UQ34GFA1 and Z3UQ28GFA1 monitor input current, inverter phase current, and condenser fan speed continuously. Whenever electrical load or fan feedback leaves safe boundaries, the controller halts cooling and flashes the matching CH code.

Although CH22 and CH29 both relate to overcurrent protection, they monitor different points in the electrical path. Meanwhile, a stalled outdoor fan behind CH67 can rapidly trigger secondary pressure and amperage faults if ignored.

Verified LG CH22, CH29 and CH67 fault meanings summary table
CodeFault categoryVerified LG meaning and on-site diagnostic check
CH22Compressor / Electrical FaultCT2 error, alternating current input too high: clamp-test mains draw, inspect condenser heat dissipation, and verify refrigerant charge.
CH29Compressor / Electrical FaultInverter compressor amperage is too high: test compressor windings, check locked rotor condition, and verify outdoor inverter board.
CH67Fan Motor FaultOutdoor fan error: inspect blade obstruction, shaft bearings, DC fan motor feedback signal, and outdoor PCB fan port.

Why heat buildup on HDB ledges triggers overcurrent faults

Compact HDB aircon ledges with louver grilles restrict exhaust airflow whenever outdoor fins collect construction dust or kitchen grease. Trapped hot air forces discharge pressure higher, pushing total alternating current input into CH22 limits and inverter compressor draw into CH29 territory.

Overcharged refrigerant from an unweighed gas top-up produces the same electrical overload. Technicians verify superheat, subcooling, and clamp-meter current before declaring the compressor or control board defective.

Isolating outdoor fan motors from outdoor control boards

Keep electrical breakers untouched and never reach through condenser grilles to spin blades while power remains connected. A seized DC fan motor can overload the outdoor board's driver circuit if restarted repeatedly.

Technicians spin the fan hub manually with the isolator locked off, test motor winding pins for shorts, and check board drive voltage. Faulty fan motors are swapped directly, while any damaged outdoor PCB is replaced as a complete factory board rather than repaired.

Common questions

Can a clogged outdoor condenser cause LG CH22 or CH29 overcurrent errors?
Severely choked condenser coils and blocked HDB ledge airflow raise head pressure sharply, forcing both mains current and compressor phase amperage past LG CH22 and CH29 safety thresholds. Thorough outdoor coil washing and accurate refrigerant charge verification always precede replacing expensive electrical hardware.
What happens if an LG CH67 outdoor fan error is left unaddressed?
Running an aircon repeatedly after an LG CH67 outdoor fan error traps extreme heat inside the condenser cabinet and stresses the inverter board. Inspecting for jammed debris, seized motor bearings, or a failed fan driver circuit prevents secondary compressor damage.
How do technicians distinguish an LG fan motor failure from a board fault?
Technicians disconnect the outdoor fan plug with power isolated, measure pin-to-pin resistance across the motor connector, and test supply plus feedback signals from the outdoor PCB. A shorted motor requires motor replacement, whereas missing board output calls for a full PCB replacement.

Sources

Sources checked .

  1. LG Singapore Servicing Support
  2. LG Warranty Terms