Skip to main content

Mitsubishi Starmex 5 Blinks and 6 Blinks Fault Singapore

On Mitsubishi Electric Starmex splits, 5 operation lamp blinks indicate an outdoor unit protection fault such as inverter or condenser shutdown, while 6 blinks signal indoor-to-outdoor communication failure. Counting flashes accurately helps Singapore technicians isolate outdoor PCB, compressor, or wiring issues swiftly.

On this page

According to Mitsubishi Electric Singapore's Single and Multi Split Error Code guide, repeating blinks on the indoor operation indicator light correspond directly to specific fault groups. Five flashes followed by a pause generally point to outdoor inverter, thermistor, or compressor protection faults, whereas six flashes point to broken indoor-to-outdoor serial transmission or outdoor power loss.

Because outdoor error details live on the condenser board diagnostic LEDs, field technicians inspect both indoor blink rhythm and outdoor board indicators before quoting replacement parts.

Separating Starmex 5-blink and 6-blink lamp patterns summary table
Indoor lamp patternPrimary fault domainOnsite isolation step
5 blinks repeatingOutdoor inverter, compressor overcurrent, or discharge heatCheck outdoor board LED flashes, compressor windings, and condenser fins
6 blinks on one room onlySingle-branch signal wire break or indoor PCB faultVerify continuity between bedroom terminal block and outdoor port
6 blinks across all bedroomsOutdoor supply loss or dead outdoor inverter PCBTest outdoor mains voltage and serial pulse before replacing outdoor PCB

Why video timing beats guessing or power resets

Pause length between flashes makes 5 blinks easy to confuse with 6 blinks during a quick glance. Capturing a brief phone video lets technicians verify the exact blink count before climbing out to condo ledges.

Leave electrical circuit breakers and outdoor isolators undisturbed instead of toggling power repeatedly to clear blinking lights. If a shorted outdoor inverter module caused the shutdown, repeated resets worsen electrical stress.

Repairing versus upgrading ageing Starmex condensers

Loose outdoor terminal splices, heat-choked condenser fins, or a single failed outdoor PCB on a four-to-six-year-old Starmex condenser normally justify targeted repair. Defective Starmex PCBs are always replaced as factory-matched boards rather than patched by hand soldering.

On condensers past eight to ten years showing both compressor winding wear and outdoor board failure, upgrading to a verified 5-tick R32 Starmex model like the MXY-3H28VG or MXY-4H33VG brings stronger efficiency and fresh warranty cover.

Common questions

How do you count Mitsubishi Electric Starmex operation lamp blinks accurately?
Watch the green indoor operation light through two complete cycles and count only the rapid flashes between clear two-to-three-second pauses. Recording a short smartphone video makes counting effortless and helps technicians distinguish between five-blink outdoor faults and six-blink communication errors before arrival.
Does a 6-blink Mitsubishi Starmex fault always mean a spoilt outdoor PCB?
Six blinks signal lost communication between indoor and outdoor boards, which does not automatically confirm a ruined outdoor PCB. Corroded ledge wiring terminals, moisture inside an exterior junction box, an unpowered outdoor isolator, or one faulty indoor board can produce identical six-blink alerts.
Are Mitsubishi Starmex inverter PCBs repaired or replaced when faulty?
Faulty Mitsubishi Electric Starmex indoor and outdoor circuit boards are always replaced as complete original-spec PCB assemblies rather than repaired at component level. Full board replacement safeguards inverter drive timing, compressor overcurrent protection, and long-term electrical safety in humid Singapore homes.

Sources