Skip to main content

Aircon in an Older HDB Flat: Electrical Load and Rewiring

Whether an older HDB flat can take more aircon depends on its main switch, not its age alone. Flats with the higher electrical loading need no permit for new aircon points; the rest have limits HDB sets.

On this page

Can an older HDB flat take a new aircon?

Usually, yes. HDB blocks completed on or after 1 January 1994, and blocks that have been through the Main Upgrading Programme or the Home Improvement Programme, have the higher electrical loading of a 40A main switch.

Those flats need no HDB permit for new aircon points. Flats without the higher loading need an HDB electrical permit for a new 15A point or 20A isolator, and have limits on the aircon they can run.

Electrical work for aircon in an older HDB flat
Electrical jobMarket range in SingaporeOur rate
New 15A aircon power point from the board$250–$350 per jobQuoted per job
20A isolator switch, the size HDB allows for aircon$180–$500 per jobQuoted per job
Distribution board replaced or upgraded$280–$900 per job
Full rewiring, 3-room or 4-room flat$2,000–$6,000 per job

New wiring in an HDB flat runs in trunking or above a false ceiling; HDB bars embedding it in concrete or plaster. A board upgrade varies with the number of circuits.

Market ranges: published rates from 3 Singapore operators; published rates from 4 Singapore operators. Checked 20 Nov 2026.

Our rates are from our rate card.

Check which kind of flat you have

The main switch at the distribution board shows the rating. If in doubt, a licensed electrical worker can confirm it.

Check which kind of flat you have summary table
Your flatWhat HDB allowsWhat to do
Block from 1994 or later, or upgraded under MUP or HIPHigher loading, 40A main switch; no permit for new aircon points; at most two split-type condensing unitsBook the installation; a licensed electrical worker handles any new point
Older block, not upgraded, using an existing approved pointNo permit needed for the existing 15A point or 20A isolatorCheck the total running current stays within HDB's limit
Older block, not upgraded, needing a new pointHDB electrical permit needed firstApply for the permit before the installation

Limits on flats without the higher loading

HDB caps the total running current of the aircon in these flats: 8.5A for 3-room, 4-room and 5-room flats, executive maisonettes and multi-generation flats, and 5A for 1-room and 2-room flats. A system above the cap needs a smaller system or a change in the flat's loading, which a licensed electrical worker advises on.

Compare the new outdoor unit's rated running current with the cap before buying.

Who does the electrical work

Only a licensed electrical worker may do the electrical work. New wiring is tested before it is switched on, and HDB requires an endorsed SP Services form for testing new wiring in a flat.

Snowflake Aircon Services prices electrical work separately, and licensed electricians handle it where it is required.

Common questions

How do I know if my HDB flat has the higher electrical loading?
An HDB flat has the higher electrical loading if its block was completed on or after 1 January 1994, or has been through the Main Upgrading Programme or Home Improvement Programme. These flats have a 40A main switch, shown on the distribution board. A licensed electrical worker can confirm it.
Do I need an HDB permit to install an aircon?
Not if the flat has the higher electrical loading, or if the aircon uses an existing approved 15A point or 20A isolator. A flat without the higher loading needs an HDB electrical permit before a new 15A point or 20A isolator is installed for the aircon.
Does an older HDB flat need rewiring for a System 4?
Sometimes. A flat without the higher electrical loading has an HDB cap on aircon running current, 8.5A for 3-room to 5-room flats, which a System 4 may exceed. Then the options are a smaller system or a change in the flat's loading, on a licensed electrical worker's advice.
Who can install the power point for an aircon in an HDB flat?
Only a licensed electrical worker can install a power point or isolator for an aircon in an HDB flat, because Singapore's rules reserve all electrical works for licensed workers. New wiring is then tested, with HDB requiring an endorsed SP Services form for that testing.

Sources