Describe your situation.We’ll assess and advise the right next step.
BCA-registered10,000+ jobs completed
Clementi is not one uniform estate. Homes sit across older Clementi HDB blocks, West Coast and Faber condos, landed pockets near Sunset Way, and newer BTO corridors. Taken together, that usually means older fittings, sensor or motor wear, and leak paths to rule out before quoting a fix:
Older Clementi blocks can carry decades-old isolators, pipe runs, and drain fittings. The flat's infrastructure can matter as much as the aircon body.
Usual faults
Repeat top-ups, trips, or weak cooling that need leak and electrical checks before another refill.
Clementi cases often look like a board or wiring problem until the basic components are checked. Thermistors, fan motors, and bearings can drift or wear with age.
Usual faults
Mid-cycle shutdowns or startup rattles that point to sensors or motor bearings, not always PCB failure.
West Coast, Faber, and concealed condo systems can make drainage paths less obvious. We trace the drain route before quoting chemical servicing or parts.
Usual faults
Repeat dripping, musty smell, or cold rooms that still feel damp.
Short diagnostic notes. Open the case study if the symptom looks familiar.
Pick the closest problem to see the likely causes, then message us with what you’re seeing.
Warm air, weak airflow, or one room that will not cool down.
Likely causes
Dripping indoor unit, wet wall, or a drain choke that keeps coming back.
Likely causes
Grinding, rattling, buzzing, or a new vibration when the unit runs.
Likely causes
Musty, sour, or burnt smell during cooling or when the unit starts.
Likely causes
Cuts the power, will not start, or flashing a fault code.
Likely causes
Something else, or hard to describe? Tell us what you are seeing and we will work it out.
Tell us what's happening: "not cold", "leaking", "breaker trips", and roughly when it started. A photo or short clip helps with leaks, error codes, or odd noises.
We explain what the symptom points to, then recommend the next step: on-site diagnosis, servicing, repair, replacement, or monitoring if a visit can wait.
When you're ready, we confirm the scope, timing, and address, then get you booked in the same chat.
Diagnosis decides the service: repair, servicing, leak/gas checks, drainage, chemical cleaning, or installation.
We handle aircon work across Clementi: HDB blocks, condos, shops, offices, and industrial premises. Send the address or building name and we'll confirm access before quoting the work.
Tell us what’s going on. Symptoms, setup, photos, anything we should know. We’ll assess and come back with the right next step.
