On this page
Quick summary
Book servicing when the unit runs normally and cooling has faded gradually. Book fault-finding when it trips, shows a code, leaks again after a drain flush or fails again soon after a clean.
What each booking is actually for
Servicing is maintenance: washing the filter, flushing the drain line and wiping the coil. It removes buildup and restores normal output.
Fault-finding traces one symptom. The technician reads the code, tests parts, checks drain flow and measures refrigerant pressure. Cleaning cannot fix a trip, a code or a leak that keeps returning, so servicing is not the default first step for every complaint.
When to book servicing first
Gradual loss of cooling with no trips or alarms is usually a dirty coil and filter. A unit that takes longer to cool the room or smells musty on start-up fits the same pattern.
A unit that has gone a long time without cleaning also starts with servicing, because a clean baseline often removes the complaint. If cooling is normal afterwards, servicing was the right first booking.
When to book fault-finding first
A tripping breaker, a sudden shutoff or a blinking error light means a fault, not dirt. Cleaning first adds cost and leaves the cause in place. After a breaker trip, leave the unit off.
A complaint that returns within weeks of a service is not buildup. Gas loss, a failing part or a partial drain block that the flush missed are the usual causes. A leak that survives a drain flush points to the float switch or the pipe angle.
On a multi-split, one faulty indoor unit can look like weak cooling across the whole system. Fault-finding tests each indoor unit separately to isolate the circuit, which a standard service does not do.
| What you are seeing | Book first | Why |
|---|---|---|
| Airflow has weakened gradually, with no shutdown or code | Discuss servicing and check scope | Accessible buildup may be part of the problem |
| Breaker trips or a fault code appears | Fault-finding | The technician needs the trip or code history to choose the check |
| The same complaint returns after recent service | Fault-finding | Check what the previous work covered and what may remain |
| Water returns after a drain flush | Fault-finding | Inspect drainage and other leak sources before repeating the flush |
| The unit cools normally and is due for maintenance | Servicing | Routine work covers upkeep for the quoted unit |
What happens when you get the order wrong
Servicing a unit with an active fault means paying for a clean while it still trips or leaks, then paying again for fault-finding. Repeated services on a leaking unit cost more than one early fault check. Once a service has been done and the complaint is back, book fault-finding.
What to tell the contractor before booking
State whether the problem came on suddenly or built up. A sudden trip or first-time drip points to fault-finding; slow decline points to servicing.
Give the date and findings of the last service, since recent cleaning changes how the complaint is read. Photograph any code or blinking light and send it with the model number.